Starting The Pellet Burner; Stopping The Burner; Emergency Stop - ATTACK PELLET Series Instructions For Use Manual

Voiler for combustion of wooden pellets

Starting the pellet burner

The burner starts the stand-by mode automatically by switching on the main switch of the

boiler. The burner starts the opetation by switching on the burner switch and turning the

boiler thermostat to required boiler temperature. According to need of heat the burner

ignites and burns the pellets until the boiler thermostat cuts out. As an alternative, the

burner is controlled by the temperature sensor connected to the TS1 port on the right upper

side of circuit board. Be sure that its contacts lock properly in a place.

Stopping the pellet burner

The burner is stopped by the operating thermostat cutting out, by switching off the burner

switch (the stand-by mode) or through the burn down iniciated via menu.

NOTE:

In case of emergency, the burner can be stopped by switching off the main boiler switch and

disconnecting from the mains.

Table of Contents

Pellet 20 a Pellet 30 a