Advertisement
Pellet feeder installation
During the installation of pellet feeder it is necessary to:
1. Check if all the components were supplied.
2. Place the feeder to the storage under the angle of max. 45°.
3. Attach the closing ending to the ring on feeder drive.
4. String the chain to appropriate length and fitt it with the appropriate screw or hook on
storage (Alt.1), or on the ceiling (Alt.2). If it is to be attached to storage for pellets, the hole
to be drilled into the from wall fo the storage.
5. Install the feeding hose to the orifice of pellet feeder and feeding tube of the burner. The
connection to be fixed with attached clips.
6. Set the feeder gradient and the length of feeding hose. Hose should be lightly rounded to
avoid the accumulation of soft parts. The outlet orifice should be a little bit moved contrary
to burner feeding part.
7. Remove the hose from the burner feeding tube and put its end to the bucket, or
alternatively to smaller container. Connect the pellet feeder to the main to full fill with
pellets. When the pellets start to fall down through the hose to bucket, let the feeder run for
next few minutes to assure the continuous pellet moving.
8. Install the hose again to the burner feeding tube, fix the connexion with the clip and plug
the feeder connector into the power point on the burner.
INSTRUCTION FOR MAINTENANCE : Clean the storage for pellets from the soft
parts 2-4 times a year !
Installation parts of 1,5 m long pellet feeder:
Feeder, chain 1,3 m, hose of
diameter 65 mm length of 1 m
2 pcs pf plug-in parts of 4 mm
2 pcs of clips to hose 58-75 mm
21
Advertisement
Chapters
