Control mode
Base setup model
Mod. Name
GRAUBELE
Stick mode
Module
HoTT
bind
Rcv Ch Map
R08
SEL
Fixed-wing model
MODE 1 (Throttle right)
Elevator
Full throttle
Elevator
Motor idle
MODE 3 (Throttle right)
Elevator
Full throttle
Elevator
Motor idle
Car / boat
MODE 1 (for/backward right)
forward/backward
forward/backward
MODE 3 (for/backward right)
forward/backward
forward/backward
Binding type
Base setup model
Mod. Name
GRAUBELE
Control mode
Binding type
Model
Module
HoTT
n/a
SEL
33028_mc_28_Teil2_jh
In this function you can choose a control mode which will be used
for this model memory. In this way it will be determined which con-
trol movement of the related control stick will we associated to
1
n/a
which channel. Tap n the SET button, set the desired mode through
n/a
the selection buttons. In the "receiver assignation" section you can
see where each servo should be connected.
MODE 2 (Throttle left)
Full throttle
Elevator
Motor idle
Elevator
MODE 4 (Throttle left)
Full throttle
Elevator
Motor idle
Elevator
MODE 2 (for/backward left)
forward/backward
forward/backward
MODE 4 (for/backward left)
forward/backward
forward/backward
Note
This menu line is only visible until no receiver is bound to the active
model memory.
This option must be selected before the binding of a receiver. You
can select between "Global" and "Model", which means:
1
"Global": All bound receivers react to the signals of each model
memory of the transmitter. For safety reasons it is then only possible
n/a
to change model memory only after having switched the receiver off.
"Model": Bound receivers react only to the signals of the assigned
model memory. An accidental use thorough a non specifically
assigned model memory is not possible.
Helicopter model / Copter model
MODE 1 (Throttle right)
Nick
Motor / Pitch
Nick
Motor / Pitch
MODE 3 (Throttle right)
Nick
Motor / Pitch
Nick
Motor / Pitch
MODE 2 (Throttle left)
Motor / Pitch
Nick
Motor / Pitch
Nick
MODE 4 (Throttle left)
Motor / Pitch
Nick
Motor / Pitch
Nick
19 / 80