Trainer; Teacher Function; Pupil Transmitter; Teacher Transmitter - GRAUPNER mc-26 Programming Manual

Trainer

T/P:Pupil
Pupil
Teacher
1 2 3 4 5
SW: ––– BIND: n/a
T/P:Pupil
Pupil
Teacher
7 8 9 10 11
SW: ––– BIND: ON
T/P:Teacher
Pupil
Teacher

7 8 9 10 11
SW: 8 BIND: ON
Transmitter output
Tx. output swap
Tx Ch Output
1
Tx Ch Output
2
Tx Ch 3 Output
Tx Ch 4 Output
SEL
58 / 80
In this menu you can set the functions for the teacher / pupil oper-
ation. The operation can be wireless or wired with HoTT transmit-
ters. Please also observe the instructions of the pupil transmitter.
6
Connection through cable (DSC port):

Teacher function

Pupil transmitter:

ming, select the mode setting.

Teacher transmitter:

over to the pupil transmitter. If the model has 2 aileron servos, then
only channel 2 may be transferred since channel 5 is already mixed
through the model type 2 AILE.
Select "NEXT" at the bottom left of the display and assign a switch to
transfer to the student.
Establish the cable connection through the DSC socket, observe the
instructions of the pupil's transmitter.
In flight mode the control can now be transferred to the pupil through
the assigned switch.
Wireless connection (HoTT system):
Teacher function
Pupil transmitter:
ming, select the mode setting.
12
Teacher transmitter:
over to the pupil transmitter. If the model has 2 aileron servos, then
only channel 2 may be transferred since channel 5 is already mixed
through the model type 2 AILE.
Select "NEXT" at the bottom left of the display and assign a switch to
transfer to the student.
12
Binding the Pupil transmitter to the Teacher transmitter:
Select "BIND" in the student display at the bottom right, immediately
select "BIND" in the teacher display at the bottom right
In this menu you can freely split the 16 control channels of the trans-
mitter to the outputs.
1
2
Select the desired channel and assign it to the output.
3
4
A control channel can also be assigned to multiple outputs.
start a new model memory without program-
Select the channels which have to be handed
start a new model memory without program-
Select the channels which have to be handed
33028_mc_28_Teil2_jh