Ring Limit - GRAUPNER mc-26 Programming Manual

Ring limit

Ring limiter
4 3 4 3 OFF
4 3 10 9 OFF
4 3 12 11 OFF
X Y X Y
Input Output SET
R.lim.1
CH 4 CH 3
100% 100%
0% 0%
max-X
R. lim.1
CH 4 CH 3
100% 100%
0% 0%
 -X
33028_mc_28_Teil2_jh
This function is used to control up to three of the so-called
Voith-Schneider drives of ship models. The function only appears in
the multi-function menu when the model type "Boat" has been
selected.
In the "Input" column, select the two channels which are to be used
for controlling the drive unit. You can also use channel 5 - 16. A con-
trol must then be assigned on the selected channel.
In the "Output" column you can define the output channels, which
then control the servos of the drive unit.
Activating the ring limiter in the "SET" column.
Change to the setting side of the ring limiter in the "=>" column.
In the setting page of the respective "ring limiter" the maximum
travel is set between 25 and 125% in the first line and the measure
of the limitation of the total deflection is set in the second line
between:
0 % Circular limiter ()
100 % without limiter () - The limit is the mechanical limit stop of
the respective control stick.
In the two upper "max-X" and "max-Y" value fields you can set the
required (servo travel) limit in the range of 25 - 125%, separately for
both control functions "left / right" and "forward / backward" . The
adjustment must be done in such a way that the servos in the model
are no longer running.
In the line underneath, labeled "<=>-X" and "<=>-Y" in the
lower-left side, you can influence the shape of the limiter between
"circular" and "square" with setting values between 0 and maximum
125 %. The setting value can never be greater than the value in the
field above.
75 / 80