Dual Mixer; Fail Safe - GRAUPNER mc-26 Programming Manual

Dual mixer

Dual mixer
Mixer1 ?? ??
Mixer2 ?? ??
Mixer3 ?? ??
Mixer4 ?? ??
Typ zu

Fail Safe

Fail-safe adjust
Pos.
hold
1 2 3 4 5 6
DELAY: 0.25s
Fail-safe adjust
Pos.
Position stored
hold
13 14 15 16
DELAY: 0.25s
33028_mc_28_Teil2_jh
0%
In this menu, you can link two control functions with four freely pro-
0%
0%
grammable dual mixers.
0%
Diff.
Example (V-tail mixer):
In the case of a dual mixer, the control signals are output from the
two controls to both outputs of the mixers.
In the right column, you can set the differentiation value between
the two outputs.
In this menu you can set the positions of all the servos, which are
approached in the event of a fault in the radio connection. This also
applies to the period when the receiver is switched on until the radio
STO
connection to the transmitter is reached.
You have the following possibilities (switch the receiver on:
"Hold" - In the event of a missing radio connection, the servo is held
at the last position before the radio connection failed. When the
radio connection is restored, the servo reacts normally again.
"Pos." - In the event of a missing radio connection, the servo is moved
to a certain position after the set delay time.
Position setting:
• Set the "Pos." Function of the desired channel
• Delay setting
STO
• Move the servo in the desired position
• Select STO, tap the SET button
• The position is confirmed by "Position stored"
Elevator control stick
3
V-Tail
mixer
4
Rudder control stick
3
Rudder / Elevator left
Rudder / Elevator right
4
57 / 80