Free Mixers; Mixer Programming Step By Step - GRAUPNER mc-26 Programming Manual

Free mixers

Phase timers
Wing mixers
Free mixers
MIX active/phase
MIX-only channel
Dual mixer
M1 ?? ??
M2 ?? ??
M3
?? ??
M4 ?? ??
M5 ?? ??
fr
Typ zu
M8 ?? ??
C9 ?? ??
C10 ?? ??
C11 ?? ??
C12 ?? ??
fr
Typ zu
L.Mix1 1 3
Mix input
0% 0%
Offset
0%
SYM ASY
33028_mc_28_Teil2_jh
In this menu you can find free programmable linear and curve mix-
ers.
Regardless of the type of model chosen, in each model memory are
available eight linear mixers with the designation M1 to M8 as well
as four curve mixers with the designation C9 to C12.

Mixer programming step by step:

1. Select the desired mixer
2. Tap the SER button, the field will be highlighted
3. Set the mixer input "From" though the selection keys
4. Tap the SET button, then change to the column "To" using the
selection keys
5. Tap the SER button, the field will be highlighted
6. Select the mixer output "To" with the selection keys.
7. Set the mixer type in the second "Type" column
• Tr = Trim
• P = Phase (only for model type "Heli")
• -> Series switch
8. Assign a switch or a control switch in the column "
9. In the column " " define the mixer component and the mixer
offset in the following display page. If a switch has been assigned,
the display page will be shown only if the switch is actuated.
Possible settings in the columns
"Type"
Tr : This function can be selected only in the channels one to four.
here you can select if the mixer input trim also has to act on the
mixer output.
Tr -> : The trim acts also to the series switch
-> : Series switch of the mixers, example:
Without series switch
6 6
MIX 1
7 7
MIX 2
8
"
With series switch
6 6
MIX 1
7 7
MIX 2
8
53 / 80