AJAX Hub User Manual page 253

Delays in night mode
Alert if moved
Power supply of the external detector
Arm in night mode
Activate the siren if an alarm is detected
Signal Strength Test
Attenuation Test
User Guide
Unpair Device
Set the following parameters in the Transmitter settings:
• The state of the external detector contact, which can be normally closed or normally open.
•
The type (mode) of the external detector that can be bistable or pulse.
Delay turned on when using night mode
The accelerometer turning on the Transmitter to provide an
alarm in the event of device movement
Turning the power on in 3.3 V external detector:
•
Disabled if hub is disarmed
•
Always disabled
•
Always active
If active, the device will switch to armed mode when using night
mode
HomeSiren StreetSiren
If active, and
detected
Switches the device to the signal strength test mode
Switches the device to the signal fade test mode (available in
detectors with firmware version 3.50 and later)
Opens the device User Guide
Disconnects the device from the hub and deletes its settings
actuate if an alarm is