gefran SIEIDrive ADV100 Functions Description And Parameters List page 81

Menu PAR Description
21.19 2474 Damping threshold 2
Setting of the second damping gain regulation threshold. These settings are usually effective for intermediate fre-
quencies and make it possible to limit motor oscillations.
Menu PAR Description
21.20 2480 Vf min frequency
Setting of the minimum frequency in the V/f control mode. This represents the minimum output frequency, below
which frequency regulations are ineffective. It is not possible to go below this value, regardless of the reference that
has been set.
Menu PAR Description
21.21 2482 Vf min freq delay
Setting of the delay for the minimum frequency signal in the V/f control mode.
Menu PAR Description
21.22 2490 Dig Vf scale
Setting of a digital multiplier factor for the drive output voltage in the V/f mode.
Menu PAR Description
21.23 2492 Vf scale src
Selection of the origin (source) of the signal to be used to set a multiplier factor for the drive output voltage. The as-
sociable functions are listed in the "L_REF" selection list.
ADV100 • Functions description and parameters list
UM Type FB BIT
Hz INT16
UM Type FB BIT
Hz FLOAT
UM Type FB BIT
ms UINT16
UM Type FB BIT
FLOAT 16/32
UM Type FB BIT
LINK 16/32
Def Min
30 5
Def Min
1.0 0.2
Def Min
800 0
Def Min
1.0 0.0
Def Min
3374 0
Max Acc Mod
100 ERW V
Max Acc Mod
5.0 ERW V
Max Acc Mod
5000 ERW V
Max Acc Mod
1.0 ERWZ V
Max Acc Mod
16384 ERW V
81