Removing Hot-Plug Pci Boards - Fujitsu PRIMERGY RX600 S3 SAS Operating Manual

Hot-plug PCI boards
8.5.1

Removing hot-plug PCI boards

Ê Open the housing cover (see
Ê Start the PCI hot-plug software (PCI Card HotReplace) if this is required by
the operating system (for example, Windows 2000). You will find operating
instructions in the README file for the PCI Hot Plug Software V3.0 on the
ServerStart Disk 1.
1
2
Figure 31: Deactivating the board
Ê To deactivate the board, press the standby button (1, LED/optical indicator)
on the board.
The standby button (1) and the power indicator (2, LED/optical indicator) of
the hot-plug PCI slot flash orange during the transition phase.
Ê Wait until the power indicator (2) goes out.
The slot is now disconnected from the power supply.
92
"Opening/closing the housing" on page
Operating manual
Hot plug components
100).
RX600 S3 SAS