Connecting The Server To The Mains - Fujitsu PRIMERGY RX600 S3 SAS Operating Manual

Connecting the server to the mains

Additional ports are located on the right of the rear side (see figure 10).
Figure 10: Ports on the right of the rear side
1 LAN port
(not currently available, reserved
for future enhancements)
Ê Connect the data cables to the server and peripherals.
I
Keyboard and mouse are each connected via USB. Separate PS/2 ports
are not provided.
4.5 Connecting the server to the mains
The server has two hot-pluggable power supply units. This ensures a redundant
power supply. If one power supply fails, the other then ensures that the server
can continue to operate as normal. Each hot pluggable power supply unit can
be replaced during live operation (see
on page 77).
V
CAUTION!
The server is automatically set to mains voltage of 200 V - 240 V. Make
sure that your local mains voltage is within this range.
48
2 SCSI port
(optional, connected to SCSI
Channel B or a separate PCI
board in the housing)
"Replacing hot-plug power supply units"
Operating manual
Hardware installation
2
1
RX600 S3 SAS