Fujitsu PRIMERGY RX600 S3 SAS Operating Manual page 97

Hot plug components
Detaching the holding plate from the removal aid
Figure 35: Detaching the holding plate from the removal aid
V
CAUTION!
When detaching the holding plate from the removal aid, pay particular
attention to the clips that fasten the plate to the holding aid. Do not raise
them more than approximately 1 mm, in other words, only lift them as far
as is required to release the holding plate. Otherwise you may damage
the clips.
Ê Do not raise the green fastening clips more than approximately 1 mm (1)
until the holding plate is released.
Ê Remove the holding plate (2) and set it aside.
I
Keep the holding plate safe for use later on.
Ê Push the fastening clips hooks down until they detach from the removal aid
(see figure 34 on page
RX600 S3 SAS
95), and keep them in a safe place.
Operating manual
Hot-plug PCI boards
97