Fujitsu PRIMERGY RX600 S3 SAS Operating Manual page 45

Hardware installation
1
Figure 7: Securing the server
Ê Place the cage nuts for fastening the front panel in the corresponding holes
on the front support upright, and fasten the server using two knurled
screws (1).
To remove the server, follow this procedure in reverse. Note that, when you
remove the server, both system support rods (see figure
right and left must be pulled out in parallel.
RX600 S3 SAS
Installing the server in the rack/...
Operating manual
1
5 on page 43) on the
45