Opening/Closing The Housing - Fujitsu PRIMERGY RX600 S3 SAS Operating Manual

Opening/closing the housing

8.6 Opening/closing the housing
V
CAUTION!
The actions described in this section may only be performed by
personnel with the appropriate technical training. Any unauthorized
opening or incorrect repairs could expose the user to risks (electric
shock, fire hazards), and could damage the equipment.
Please observe the safety information in
mation" on page
V
CAUTION!
The housing cover must be replaced as quickly as possible due to
cooling requirements, the applicable EMC (electromagnetic compati-
bility) regulations, and for fire safety.
Figure 37: Opening the housing
– To open the housing, remove the two screws (1) on the front, slide the cover
back by about 1 to 2 cm, and lift it up.
To close the house, place the cover on the housing and slide it forwards until
it locks into place. Replace and tighten the two screws (1) on the front.
100
21.
Operating manual
Hot plug components
chapter "Important infor-
1
RX600 S3 SAS
1