Important Safety Instructions - MUTOH ValueJet VJ-1638UH Operation Manual

VJ-1638UH OPERATION MANUAL
1.2

Important safety instructions

This section explains general cautions that must be followed in order to use this printer safely.
WARNING
Do not install this printer in the following places.
It may cause an injury if the printer falls down.
• On a shaky stand
• Slanting location
• Place where vibration from other machines is transmitted.
Do not step on this printer or place heavy things on top of it.
It may cause an injury if the printer falls down.
Do not block the vent by covering the printer with cloths, such as a blanket or tablecloth.
If the vent is blocked, heat may accumulate inside the printer and it may cause fire.
Do not install the printer where it is humid or dusty.
It could lead to an electric shock and fire.
Do not use a damaged power cable.
It could lead to an electric shock and fire.
Do not pull out or insert the power plug with a wet hand.
This could lead to an electric shock.
Do not connect an earth wire to the following places.
• Gas pipe
There is a possibility of ignition and explosion.
• Earth wire of telephone cables and lightning rods
Heavy current might flow whenever lightning strikes.
• Water pipe and faucet
The earth might not work if a plastic pipe is connected in the middle of the metal pipe.
Do not insert or drop metal or flammable objects into the printer through openings such as a vent.
It could lead to an electric shock or fire.
If foreign substances or liquids such as water entered the printer, do not use the printer as it is.
It could lead to an electric shock or fire.
Immediately turn OFF the power switch, disconnect the power plug from the electric socket, and contact your
local MUTOH dealer.
Wire the various cords as directed in the Operation Manual.
Mistaken wiring could cause fire.
Be sure to use the specified power cord set.
Using a power cord set other than the specified can cause an electric shock or fire.
Use the power cord set compliant with the safety standards, power-supply voltage, and plug shape of the country
where the printer is used.
Use a power cord set which is equipped with a protective earth, and securely connect it to the outlet.
Make sure to use only the specified power supply (AC 100-120 V or AC 200-240 V).
If a power supply other than the specified voltage is used, it could cause an electric shock and fire.
1.2 Important safety instructions
1 Safety instructions
15