5.3.18 Start Feed Menu; 5.3.19 Initialization Menu - MUTOH ValueJet VJ-1638UH Operation Manual

5 Panel setup menu

5.3.18 Start Feed menu

In the Start Feed menu, you can change the margin setting between images.
Setup Item
Start Feed
NOTE
With take-up system: if you want to set "Start Feed" to below 0, set "Page Gap" to "Narrow".
If not, the Start Feed setting is not reflected properly.
5.3.2.1 Page Gap menu

5.3.19 Initialization menu

Returns the settings of the printer to default.
Use this if you enter a wrong setting value by mistake, or if you want to set the value back to the default.
Setup item
Initialization
270
Description
-10 mm to <0 mm> to
500 mm
—
Setting
ALL
Setup menu
—
VJ-1638UH OPERATION MANUAL
Setup Item
• Value over 0: The margin setting between images will be
wider than when setting "0".
• Value equal to 0: The default margin setting between
images will be applied.
• Value below 0: The margin setting between images will be
smaller than when setting "0".
• [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.3 Setup menu
Description
All settings can be returned to factory default.
The setting of the Setup menu is returned to factory default.
• [Enter] key:
"Initializing" is displayed on the operation panel and the
printer initializes the setting.
• [Cancel] key: shifts to the previous menu without
initialization.
5.3 Setup menu
5.3 Setup menu