Using Static Addressing; Clearing The Arp Cache - Avaya S8700 Series Manual

Using static addressing

For the IPSI circuit packs to get static IP addresses, you must administer them directly through
the Ethernet port connection on the IPSI faceplate (top port). See
IPSI on page 125.
Figure 21: Connecting directly to the IPSI
cadlipsi KLC 031502
Figure notes:
1. Services laptop
2. PCMCIA Network Interface Card (NIC)
Note:
Make sure you have the password before proceeding.
Note:

Clearing the ARP cache

Depending on your laptop computer's operating system (generally Windows 2000), you may
need to clear the Address Resolution Protocol (ARP) cache before entering a new IP address. If
you enter an IP address, and your computer cannot connect, then you may need to clear the
cache.
1. On your laptop computer click Start > Run to open the Run dialog box.
2. Type command and press Enter to open a MS-DOS Command Line window.
1
2
Postmigration administration
Connecting directly to the
3
4
3. NIC adapter cable (if necessary)
4. CAT5 crossover cable to IPSI
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
Issue 4 January 2005 125