Festo CPX-FB14 Electronic Manual page 21

1. Installation
Fitting
Festo P.BE−CPX−FB14−E N en 0308a
Fit the field bus node as follows:
1. Place the field bus node in the manifold sub−base. Make
sure that the grooves with the terminals for electrical con
tact on the bottom of the field bus node lie directly above
the contact rails. Press the field bus node carefully and
without tilting as far as possible into the manifold sub−
base.
2. Tighten the screws at first only by hand. Insert the screws
so that the self−boring threads can be used.
Tighten the screws with a Torx screwdriver size T10 with
0.9 ... 1.1 Nm.
1−7