Menu Handling; Save Settings - Tally Dascom 2810 User Manual

The Menu
Load Menu=1
Set < > Exit
1 2 3
If changing menus it is possible that the printer initializes due to different
emulation settings.

Menu handling

You can navigate in the current menu using the four function and selection keys
arranged below the LC display field. Each function and parameter displayed in
the LCD is executed or selected by the corresponding key below, respectively.
Usually two parameter groups are combined at one level. In the following
example, these are the LPI and Skip parameter groups.
If you do not wish to change one of the two parameters you can either press the
Next key (to access the two following parameter groups in the menu), or you can
press the Back key (to access the two previous parameter groups in the menu).
If you want to change a setting, (e.g. the line density), then press the LPI key (LPI
= lines per inch) to access the actual parameter level.
The currently valid setting is marked by a
setting is 6 lpi). With the < and > keys you can view the other parameters
available for this setting.
Example:
back to the previous

Save settings

Once the desired parameter is displayed on the LC display, you can save it by
pressing the Set key. The parameter is then set and the printer automatically
displays the parameter groups again. With the Exit key you can leave the
sublevel without saving your changes.
38
Now press the < (2) or > (3) key repeatedly until Load
*
Menu=3 appears.
Online
Then select menu no. 3 as the current setting using the Set
4
Setup
key (1). The currently active setting is marked with an
asterisk (
parameter groups
6 LPI
Set <
*
).
*
(in the example below the current
LPI Skip
Back
* Skip = 0.0 Inch
> Exit Set
on to the next
Next
parameter groups
< > Exit
User Guide
*