Messages In The Lc Display - Tally Dascom 2810 User Manual

User Guide

Messages in the LC display

If the printer detects an internal fault or user error or if it expects you to do
something, a message will appear in the LC display. It also displays the status
during an operation (e.g. Initializing). Below you will find a list of messages with
brief descriptions of each message. The messages are described in greater detail
in the chapter
Message
Eject error
Hardware Alarm
Initializing
Load error
Load paper from
Loading default
Out of paper
Paperwidth error
Parity error
Park position
Press any key
PW sensor defect
Selftest
Tear Paper off
AED Error
Error messages via the
Meaning
The printer cannot eject the paper/advance it to park
position.
Internal hardware error. Try power cycling the printer. If
the message appears again, contact your dealer or
service technician.
This message appears during the printer's initializing
phase after switching on the printer.
The printer cannot draw in the loaded paper.
The printer has detected paper end during
operation/printer was switched on with no paper
loaded.
Factory defined parameters will be reloaded in all
available menus after switching on the printer.
The printer has detected paper end during operation /
printer was switched on with no paper loaded.
Print characters override the detected right paper
margin.
A parity error during data transmission is indicated.
Paper is not being fed into print position.
The user is requested to press any key.
The automatic paper width detection cannot detect the
left paper margin.
After power-on, the printer executes a short hardware
self-test.
The user is requested to tear off paper which has been
advanced to the tear edge.
AED sensor cannot locate paper transport holes (only
if a cut device is installed).
display.
The control panel
23