Advertisement
ASSEMBLY PROCEDURE
Following the instructions as presented will help ensure
the proper assembly of your greenhouse. Failing to follow
these steps may result in an improperly assembled and
anchored greenhouse and will void all warranty and
protection the owner is entitled.
The steps outlining the assembly process are as follows:
1. Verify that all parts are included in the shipment. Notify
Customer Service for questions or concerns.
2. Read these instructions and all additional
documentation included with the shipment before you
begin assembling the greenhouse.
Use these instructions and the bill of materials list
inside each box when assembling the greenhouse.
3. Gather the tools, bracing, ladders (and lifts if
applicable), and assistance needed to assemble the
greenhouse.
4. Re-evaluate the location and site based on the
information and precautions presented in the
documentation included with the shipment.
5. Lay out the site (if this has not been completed).
6. Assemble the base frame and greenhouse components
in the order they are presented in these instructions.
7. Anchor the greenhouse as instructed. See information
beginning on page 24.
8. Read the Greenhouse Care and Maintenance
information near the end of these instructions.
9. Complete and return all warranty information as
instructed.
REQUIRED TOOLS
The following list identifies the main tools needed to
assemble the shelter. Additional tools and supports may be
needed depending on the structure, location, and
application.
•
Tape measure or measuring device
•
Marker to mark UV-side of panels during assembly
•
Variable speed drill and sockets (cordless with
extra batteries works best)
•
Small hammer and gloves
•
Adjustable pliers and wrench (or ratchet)
•
Phillips screwdriver
•
Ladders and/or work platforms
•
Caulk gun for silicone application
Revision date: 01.01.16
GROWSPAN
ESTATE ELITE ATTACHED GREENHOUSES
™
GREENHOUSE PARTS
All greenhouse sections (e.g., roof, sides, end walls, etc.)
ship individually in numbered boxes. The quantity of boxes
may differ depending on the greenhouse.
To prevent mixing the parts while assembling the
greenhouse, select the boxes as instructed and open that
box only and assemble its contents.
OPEN BOXES AS INSTRUCTED TO PREVENT MIXING
OF THE CONTENTS.
NOTE: Some photos and diagrams throughout these
instructions may show a greenhouse with slightly different
dimensions, color, or design. The assembly procedures
are identical regardless of these differences. Notable
differences are addressed.
For a quick overview of this greenhouse, consult the
diagrams in the Quick Start section near the back of these
instructions.
Those not familiar with the assembly of similar structures
and the use of common hand tools must seek the
assistance of someone with such experience.
WARNING: Do not allow the polycarbonate panels to
remain in direct sunlight until they are installed. Doing
so will cause the protective film to become difficult if not
impossible to remove.
Consult Page 32 for additional polycarbonate
information. And, Step 10 on that page, for "how to use
vent tape" (additional purchase required) information
before installing any polycarbonate panel.
PART IDENTIFICATION NUMBERS
All main parts include a stamped ID number. Use this
number when selecting the required parts during the
assembly.
NOTE: The locations of the part numbers on the
components may vary. Refer to the Bill of Materials shipped
within each box for a description of each part.
17
17
3
Advertisement
