Advertisement
ASSEMBLE THE END WALL FRAMES (CONTINUED)
Up to this point, all end wall frame members are
attached except for the base rail. The dotted line shows
the position of the base rail. See photo below.
14A
20. With the end wall assembled as shown, locate the base
rail (10) and position it at the ends of the lower supports
and vertical supports.
NOTE: The slot used to attach the base rail to
the lower support is positioned to the inside of the
greenhouse. The view above is an end view of the
base rail. Actual rail may differ slightly in design.
21. With the base rail in position, insert the bolt of one (1)
door support through the pre-drilled hole in the base
rail and hold the bolt in place. Do not install the nut on
the bolt at this time.
Vertical Support
Base Rail (10)
Revision date: 01.01.16
Vertical Support
14A
Notch toward the inside
of the greenhouse.
Base Rail (10)
To the top of the
end wall frame.
GROWSPAN
ESTATE ELITE ATTACHED GREENHOUSES
™
22. Take the free end of the diagonal strut and insert the
bolt of the door support through the pre-drilled hole in
the diagonal strut and install the nut.
ATTENTION: Verify that the bottom of the door support
is tightly seated against the top of the base rail before
you tighten the bolt and nut.
Flush to the top
of the base rail.
View is from the outside of the greenhouse looking
at the top of the base rail where the door support is
attached.
23. With the support tight against the top of the base rail,
tighten the nut and repeat the steps to attach the
remaining door support and diagonal strut to the end
wall base rail.
24. After attaching both struts and door supports to the
base rail, move to one end of the base rail and attach
the lower end of the vertical support.
Vertical Support
14A
Base Rail (10)
11
Advertisement
