Advertisement
GROWSPAN
ESTATE ELITE ATTACHED GREENHOUSES
™
FRAME ASSEMBLY
After assembling both gable end frames and sidewall
frames, the assemblies are attached to each other to
construct the greenhouse frame.
NOTE: The greenhouse frame must be assembled on a
clean, flat surface such as a driveway or patio. An uneven
surface will not allow the sides and ends to join properly.
In many instances, the greenhouse frame can be moved
(with assistance) to the site after it is assembled or onto the
optional base if that was purchased.
The frame in the following photos may be of a different
model. The assembly process is the same. Consult
diagrams in the Quick Start section for details.
Complete the following steps.
1. Position the assembled frame sections as shown
below.
All inside surfaces are facing up in the above photo.
2. Lift the first end wall and sidewall frames into position.
Photos above and the following photos may be of a
similar model. The assembly process is the same for
your greenhouse.
14
3. Slide a red-headed bolt into the bolt track of the end
wall frame support (14). See inside view below.
NOTE: Use a small piece of tape to keep the bolt near
the top of the bolt track if desired. Place the tape in
the same position as the finger in the photo (above) to
keep the bolt from sliding down the track.
4. Once the bolt is in the track, seat the gutter rail of the
sidewall into the corner of the end wall frame as shown.
View is from the outside of the greenhouse frame and
shows the gutter rail as seated into the corner.
Slide red bolt
into the track.
Gutter Rail
Revision date: 01.01.16
Advertisement
