Advertisement
ASSEMBLE THE END WALL FRAMES (CONTINUED)
10. Slightly tighten the lower two bolts and remove the
template.
18
11. Locate the first diagonal strut, loosen the lower bolt
identified by the arrow in the photo below and attach
one end of the diagonal strut to the bolt.
Lower Bolt
Diagonal Strut (13)
Consult the End Frame Diagram for clarification.
NOTE: Do not tighten the two bolts that secure the
lower support to the angled bracket at this time. The
diagonal strut must be allowed to move to align it with
the base rail of the end wall frame in a later step.
Gable end frame should resemble the photo below.
17
Base Rail Location
Revision date: 01.01.16
GROWSPAN
15
Clearance
set using the
template.
14
14
13
ESTATE ELITE ATTACHED GREENHOUSES
™
12. Locate the two vertical supports (marked with an X's
below) that run between the upper support and the
base rail and slide seven (7) bolts into the track of the
12-2 support and four (4) bolts into the track of the
shorter 12-1 support.
Bolt
Track
Vertical Support
X
12-2
These bolts are used to attach the vertical supports
to the upper support and the base rail. The remaining
bolts are used to secure brackets and the horizontal
braces of the end frame. See the End Frame Diagram
for clarification.
13. Take the header (65), bracket (65-2), and support
(12-1). Insert the top bolt of the support through the
pre-drilled hole in the upper support (15). Insert four (4)
bolts into track of header (65-1). Bracket fits over two
(2) bolts in the header and one bolt the 12-1 support.
Secure as shown below.
Inside View
Header (65)
Short, Vertical Support (12-1)
12-1
X
15
65-2
9
Advertisement
