Advertisement
FRAME ASSEMBLY (CONTINUED)
NOTE: If you are unable to seat the gutter rail
completely into the end wall frame as shown, loosen
the angle bracket bolts. This will allow the frame
components to move when the rail is seated in position.
Angle Bracket Bolts
5. After seating the gutter rail in position, retighten the
angle bracket bolts (if needed) and slide the bolt shown
in the next photo into position and tighten.
To attach a strut, detach the horizontal brace of the
end wall frame if needed. After the strut and bolt are
secured, reattach the end wall horizontal brace.
Horizontal
Brace
Revision date: 01.01.16
GROWSPAN
6. With assistance, place a bolt into the end wall upper
7. With the bolt in place, add a nut and tighten all bolts in
Gutter Rail
Use bolt with
a red head.
8. Move to the lower corner of the two assembled frame
Gutter Rail
Strut (33)
ESTATE ELITE ATTACHED GREENHOUSES
™
support bolt track and slide it down to the gutter rail of
the sidewall.
Peak
Slide bolt into
end wall support
track.
Photo shows sliding the bolt into the track at the
peak of the end wall frame where the upper support
connects to the top bracket.
the location shown below.
sections (the end and sidewall). See photo below.
End Frame
Base Rail (10)
Photo above shows the end frame to sidewall as seen
from the inside of the greenhouse frame assembly.
Gutter Rail
15
Advertisement
