Advertisement
SIDEWALL ASSEMBLY (CONTINUED)
3. Attach each vertical support (31) to the gutter rail by
inserting the bolt through the pre-drilled hole in the
gutter rail. Do not tighten at this time.
ATTENTION: For the sidewall support (14) with two
bolt tracks, the gutter rail (and base rail) will seat into
the slot of the support. Insert the bolt through the pre-
drilled hole in the frame member. Do not tighten.
14
Applies to
104713 and
104715
frames only.
Photo shows the double-bolt track support (14) with
the base rail seated into its slot. Top of the support is
attached to the gutter rail in a similar fashion.
NOTE: The slotted hole at each end of the gutter rail
is used to attach the end wall frame assembly to the
sidewall. Use the diagram to position the first vertical
support (31) in the correct location.
The photo above shows the vertical support (31) and
diagonal strut (33) as attached to the gutter rail of the
sidewall. View shows the inside of the frame.
Revision date: 01.01.16
GROWSPAN
4. Insert the remaining bolts, located in the bolt tracks of
X
5. Attach the struts (33) to the gutter rail as shown below.
Slot is next
to bolt track
identified by X.
6. Once all vertical supports are attached to the gutter rail
Use red-headed
bolts to attach
struts.
7. After the final sidewall is assembled, continue with the
ESTATE ELITE ATTACHED GREENHOUSES
™
the vertical supports (31), into the pre-drilled holes of
the base rail. Remember to attach diagonals where
applicable.
Gutter Rail
NOTE: Pictures may not reflect actual length. Consult
the Roof/Sidewall Frame diagrams near the end of
these documents for each length layout.
Do not fully tighten the bolts at this time.
and the base rail, tighten all bolts. Use a carpenter's
square or similar tool to square the frame as bolts are
tightened.
frame assembly procedure that follows.
13
Advertisement
