Advertisement
GROWSPAN
ESTATE ELITE ATTACHED GREENHOUSES
™
ASSEMBLE AND INSTALL THE DOORS (CONTINUED)
2. Slide the bolts into the bolt track of the door cross
members (630) and attach the cross members to the
vertical side members of each door frame.
NOTE: Seat the side frame members tightly against the
cross members (630) to maintain door width.
View shows the outside surface.
3. Continue connecting the door components until all door
frames are assembled.
4. Locate the door stop frame member (640) and attach
it to the inside top of the lower door frame. (Phillips
screws to mount this are typically included inside the
plastic that the door stop is packaged in.)
640
NOTE: When attached correctly, the 640 door stop
prevents the upper door from swinging into the
greenhouse and provides a lip for the inside latch.
28
Bolts
630
630
Inside/Back shown
The dashed line (below) shows the location of the 640
frame member shown in the photo below.
5. Attach the hinges to the greenhouse end wall frame.
(Some hinges may ship attached to the doors.)
ATTENTION: Adjust the header of the end wall if the
opening is too small for the door.
To adjust the header, loosen the bolts only in the
locations identified by the circles in the above diagram.
Secure
hinges to
end wall
frame.
End Wall Frame
Revision date: 01.01.16
Advertisement
