Advertisement
GROWSPAN
ESTATE ELITE ATTACHED GREENHOUSES
™
INSTALL METAL RETENTION CLIPS
There are two sizes of wire clips used to secure the panels
to the frame (82 and 87). Consult the Panel, Profile, and
Spring Location Diagrams near the back of this guide for
spring clip installation locations.
Continue with the following steps to install the clips on the
outside of the greenhouse.
1. With the panel in place, take a wire clip and place it
against the sidewall vertical support and panel.
Panel
Panel
2. Clip the free ends
of the wire spring
behind the lip of the
frame member and
press into place.
NOTE: Refer to the diagram for the correct wire spring
size and to properly space the wire clips.
3. Repeat steps to install and secure all sidewall panels,
then install the end panels and roof panels.
34
CAUTION: Wear
eye protection when
installing and working
with the wire clips.
Place wire clip into
position as shown.
Panel
Use a pliers if needed
to clip the spring in
place.
INSTALL THE END WALL PANELS
The end panels are installed and secured in the same
manner as the sidewall panels: The U-strip is installed at
the top and bottom; the retention clips are installed along
each side. Only the panel shape differs.
NOTE: All end panels are cut to the proper size. You do not
have to cut any polycarbonate panels.
For the door end of the greenhouse, locate these panels:
•
One (1) large, angled panels: Panel A1
•
One (1) large, angled panels: Panel B1
•
One (1) small angled panels: Panel C1 (Install this
panel above the door opening).
For the non-door end of the greenhouse, locate these
panels:
•
One (1) large, angled panels: Panel A2
•
One (1) large, angled panels: Panel B2
•
One (1) center, angled panels: Panel C2
NOTE: When installing the panels, install the UV-
protected side to the outside of the greenhouse.
B1
Panel Locations: Door End Frame (inside view)
A2
Panel Locations: Non-Door End Frame (inside view)
C1
A1
C2
B2
Revision date: 01.01.16
Advertisement
