Advertisement
ATTACH MAGNETIC DOOR STOPS (CONTINUED)
ATTENTION: Attach the doorstop to the end wall
vertical support as shown below. Verify that the stop
aligns with its mate bracket attached to the door frame
before you secure the magnetic door stop to the frame.
Fasteners shown may differ from actual fasteners.
Choose the installation option that allows the stop to
align with the bracket on the door frame.
Option A
Vertical Support
Nut
Option B
Vertical Support
Fastener
3. Repeat the steps to attach the remaining doorstop.
4. After the doorstops are in place, locate the weather-
stripping (69) and attach it to the door frame of the end
wall. See the dashed line below.
Revision date: 01.01.16
Fastener
Magnetic Stop
NOTE: Use bolts and nuts to
secure hardware to frame.
Nut
Magnetic Stop
GROWSPAN
ESTATE ELITE ATTACHED GREENHOUSES
™
Reinstall the Vents
If the vent frames were removed to install the panels,
reinstall the vents.
1. Verify that the silicone has set before moving the vents.
2. With assistance, slide the vent assembly into the
C-channel of the ridge beam and center the vent over
the open bay or bays where it will be installed.
3. Once it is in place, test the operation of the vent and
support arm.
4. Verify that a Z-bracket (77) is installed to secure each
support arm when the vent is closed.
Z-Bracket
(77)
NOTE: If no Z-bracket is present, carefully loosen a
rafter, install an extra bolt, attach the Z-bracket, and
secure the rafter.
5. Install all remaining vents (if present).
6. With all vents installed, locate the aluminum end covers
(59) for the ridge beam and install one at each end of
the beam. (Fasteners for the covers are packaged with
the covers.)
Install the end cap (59)
here on each end of the
ridge beam.
74
77
51
59
37
Advertisement
