Advertisement
GROWSPAN
ESTATE ELITE ATTACHED GREENHOUSES
™
INSTALL THE DRAIN PIPES (CONTINUED)
4. Repeat the steps as needed to attach the remaining
clamp for the first drain pipe.
5. Once all clamps are in place for one drain pipe,
place the pipe in position and connect it to the fixture
attached to the gutter rail. Use silicone to seal the
fixture-to-downspout connection.
6. Repeat the steps for the remaining drain pipes.
7. After installing the drain pipes, attach the magnetic
doorstops to the frame as shown in the next photos.
ATTENTION: Set the doors on the assembled frame at this
time (if this has not been competed yet).
36
ATTACH MAGNETIC DOOR STOPS TO THE FRAME
A magnetic doorstop is attached to the assembled frame for
each of the door sections. Parts are located in these boxes:
Greenhouse Sku Number
104711 – 104713 – 104715
691
Complete these steps:
1. Locate the required 691 doorstop and related bracket.
2. Attach the magnetic stop to the vertical support by
inserting the mounting bolts through the pre-drilled
holes in the vertical support.
End Panel
End Wall
Base Rail
Diagram below shows the door stop locations.
For door parts, use box:
No. 4-3
Wall of
Permanent
Structure
Revision date: 01.01.16
Advertisement
