Table of Contents
Advertisement
2.7.2.c
Programming "Card Only" Users by Presentation
To program a "Card Only" user by presentation (by presenting the card to the reader) use command 50. This user type gains access by
presenting their card to the reader. Refer to table 6 for details on user types. The program sequence is as follows:
1. Enter Program Mode
Press: 99 # master code *
The yellow LED flashes slowly.
2. Program the "Card Only" User.
Press: 50 # user type # user location # ** <present card>
3. Exit Program Mode
Press: *
The yellow LED stops flashing.
2.7.2.d
Programming 26-Bit "Card Only" Users without Presentation
To program a 26-bit "Card Only" user without presentation (without presenting the card to the reader) use command 51. Refer to
table 6
for details on user types. This command is useful, if you want to program a card, but you don't have the physical card with
you. When programming cards with this command, you must program the facility code, using command 32, parameter 2,
prior to programming users. The program sequence to program cards is as follows:
1. Enter Program Mode
Press: 99 # master code *
The yellow LED flashes slowly.
2. Program the "Card Only" User.
Press: 51 # user type # user location # card number * card number *
3. Exit Program Mode
Press: *
The yellow LED stops flashing.
Note: If you want to program users with a different facility code, simply change
the facility code with command 32, parameter 2 before each series of users.
2.7.2.e
Programming "Code AND Card" Users
When you are a combination "code and card" user you can present either your proximity card first at the proximity reader or enter the
code first on the prox.pad keypad. Codes can be from 1 to 6 digit in length in any combination. After you either present your card or
enter your code, the red and green LEDs alternate. This indicates that the unit is awaiting the second part of the combination before
granting access. Once access is granted, the bi-color LED turns solid green and the door unlocks. The program sequence is as follows:
1. Enter Program Mode
Press: 99 # master code *
The yellow LED flashes slowly.
2. Program the "Code AND Card" User.
Press: 50 # user type # user location # code * repeat code * <present card>
3. Exit Program Mode
Press: *
The yellow LED stops flashing.
Document # 6055676, Rev 2.2, D4b
prox.pad Installation/Programming Manual
Page 39 of 86
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
