Installation Configurations - IEI Technology prox.pad Installation & Programming Manual

Specifications Continued
Unit Capacity
Users (standalone mode only)
Transactions (standalone mode only)
Environmental (Indoor or Outdoor)
Operating Temperature
Operating Humidity
1.13

Installation Configurations

NOTE: IEI recommends that first-time installers test the prox.pad unit before actually mounting and wiring the unit. This allows you
to become familiar with its operation and save time on the job site (see section 2.6).
It is the installer's responsibility to determine the appropriate prox.pad installation configuration, which differs from installation to
installation. These three installation configurations are possible:
Wall Mounted Installation (exterior to the room to be accessed).
●
In this configuration, a single gang electrical box can be used. Typically, the prox.pad unit is wall mounted (surface mounted)
outside the access area on the unsecured side.
Glass Mounted Installation
●
In this configuration, the prox.pad unit is affixed with the four IEI supplied adhesive pads to the glass door or the window
adjacent to the door being accessed, on the interior side of the glass. The side cut-out on the unit is used to bring the wires out
of the side of the prox.pad case.
Secure Installation (or "two-stage" configuration)
●
In this configuration, the prox.pad antenna is located a maximum of 10 feet away from the keypad; the keypad is located on
the secure side of the door.
Document # 6055676, Rev 2.2, D4b
2000 Maximum (each user can have a card, PIN or both)
1000 Maximum (includes event number, time, date, and user
number if applicable)
-31° to 150° F (-35° to 66° C)
5% to 95% relative humidity, non-condensing
prox.pad Installation/Programming Manual
Page 13 of 86