Table 2: Prox.pad Pin Connectors - IEI Technology prox.pad Installation & Programming Manual

Pin Connector (on main circuit board)
P1 (5-pin connector, top left-most location)
P3 (4-pin connector, top middle location)
P2 (6-pin connector, top right-most location)
P4 (4-pin connector, bottom location)
Document # 6055676, Rev 2.2, D4b

Table 2: prox.pad Pin Connectors

Description/Use
Pin Wire Color
1 Gray
2 Green
3 Blue
4 Black
5 Red
Pin Wire Color
1 Blue
2 Brown
3 White
4 Green
Pin Wire Color
1 Green
2 Gray
3 Blue
4 Brown
5 Orange
6 White
NOTE: Pins 1, 2, 3 can be wired at the installer's option for one of
the following alarm outputs, Alarm Shunt, Forced Door, or
Propped Door. Mandatory: If you are not installing door contacts
per Figure 12, twist the white and orange wires together. If not
done, the REX input won't work.
Pin Wire Color
1 Red
2 Black
3 White
4 White
prox.pad Installation/Programming Manual
Use
Main Relay Normally Closed
Main Relay Normally Open
Main Relay Common
Ground (Power Supply)
+12V Input (Power Supply)
Use
Not Used
Wiegand LED Control
Wiegand Data 1 (SS White/Yellow)
Wiegand Data 0 (SS White/Black)
Use
Aux Relay Normally Open
Aux Relay Normally Closed
Aux Relay Common
REX Loop
Door Contact Loop
Loop Common
Use
Bi-Color LED (Red +)
Bi-Color LED (Green +)
Antenna (no polarity)
Antenna (no polarity)
Page 17 of 86