Table of Contents
Advertisement
prox.pad Installation/Programming Manual
3.3.9
Enabling/Disabling Auto-Entry
Auto-Entry is a feature that determines whether or not you need to press the * key after entering your access code on the keypad. By
default, the feature is disabled which means you are required to enter the * key after your access code to gain entry. If you enable the
feature you are not required to enter the * key after entering your code to gain entry. This feature applies only to codes that are the
same length as the master code. For example if the master code is four-digits, your user code must be four digits to use the auto-entry
feature. All codes less than four digits require the * key. Codes longer than the master code are not allowed, since you'll reach that
number of digits prior to entering the * key.
Note: When auto-entry is enabled you do not have to press the * key after "99 # master code" to enter program mode.
1. Enter Program Mode.
Press: 99 # Master Code *
The yellow LED flashes slowly.
2. To enable this feature, press: 30 # 2 # 1 # **
The yellow LED continues to blink slowly.
To disable this feature, press: 30 # 2 # 0 # **
The yellow LED continues to blink slowly.
3. Exit Program Mode.
Press: *
The yellow LED stops flashing.
3.3.10
Enabling/Disabling the Red LED
The prox.pad is equipped with a Bi-Color red/green LED. You have the option of enabling or disabling the red LED operation. By
default, the red LED is enabled and turns on/off depending on which state you have the LED wire programmed for.
1. Enter Program Mode.
Press: 99 # Master Code *
The yellow LED flashes slowly.
2. To enable the red LED, press: 30 # 9 # 1 # **
The yellow LED continues to blink slowly.
To disable the red LED, press: 30 # 9 # 0 # **
The yellow LED continues to blink slowly.
3. Exit Program Mode.
Press: *
The yellow LED stops flashing.
Page 64 of 86
Document # 6055676, Rev 2.2, D4b
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
