Table of Contents
Advertisement
prox.pad Installation/Programming Manual
Chapter 1: Introduction/Installation
1.1
About this Manual
This manual is designed for installers of the International Electronics prox.pad Standalone Proximity Reader/Keypad Access Control
System. The device has three operating modes, Stand-Alone (see Chapter 2), Wiegand Front End (see Chapter 3), and Secured Series
Front End (see Chapter 4). All wiring and programming instructions for a particular mode are grouped in a separate chapter along with
related illustrations.
Installation instructions are common to all three modes, and are provided in this chapter.
1.2
Safety Warnings and Cautions
This system must be installed in accordance with the National Electrical code (NFPA70), local codes, and the authorities having
jurisdiction.
When handling the main printed circuit board, to guard against possible static discharges, touch a grounded object before touching the
prox.pad unit. Static shock can render the product unusable.
1.3
Design Change Disclaimer
Due to design changes and product improvements, information in this manual is subject to change without notice. IEI assumes no
responsibility for any errors that may appear in this manual.
1.4
Reproduction Disclaimer
Neither this manual nor any part of it may be reproduced, photocopied, or electronically transmitted in any way without the written
permission of IEI.
1.5
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the users' authority to operate
this equipment. The reader is intended to be powered from a limited power source output of a previously certified power supply.
Page 8 of 86
Document # 6055676, Rev 2.2, D4b
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
