Deleting Users; Deleting A Single User; Deleting A Block Of Users - IEI Technology prox.pad Installation & Programming Manual

prox.pad Installation/Programming Manual
2.7.3

Deleting Users

There are two methods for deleting users from the prox.pad unit. You can either delete a single user or you can delete a block of
consecutive users. You must know the user locations for user(s) you wish to delete in order to do this. If you do not know the user
locations you can dump a user list via the IR LED to the optional Data Collection Device. Refer to the printing section for details.
2.7.3.a

Deleting a Single User

To delete a single user, follow the steps below.
1. Enter Program Mode.
Press : 99 # Master Code *
The yellow LED flashes slowly.
2. Delete the User
Press: User location # **
To delete user 100, for example, press: 100 # **
The yellow LED blinks slowly.
3. Exit Program Mode.
Press *
The yellow LED stops flashing.
2.7.3.b

Deleting a Block of Users

You can delete a block of consecutive users using command 58. This command requires you enter the starting user location you want
the deletion to begin and how many users from that point you want to delete. You must enter each value twice to ensure that you've
entered the correct number. Every user from the starting location to the ending user location is deleted. For example if you want to
delete user 10 to user 25, enter 10 in the start user value and 15 in the number of users value.
To delete a block of users, follow the steps below.
1. Enter Program Mode.
Press : 99 # Master Code *
The yellow LED flashes slowly.
2. Delete the Block of Users.
Press: 58 # start user # start user # number of users * number of users *
The yellow LED blinks rapidly for several seconds until all the users are deleted.
3. Exit Program Mode.
Press *
The yellow LED stops flashing.
Page 42 of 86 Document # 6055676, Rev 2.2, D4b