Wiegand Mode Led Indicators/Sounder Operations; Wiegand Front End Mode Default Settings; Table 9: Prox.pad Led Indicators/Sounder - Wiegand Mode - IEI Technology prox.pad Installation & Programming Manual

prox.pad Installation/Programming Manual
3.3.17

Wiegand Mode LED Indicators/Sounder Operations

The table below describes the various LED and sounder indications used in the prox.pad while in Wiegand Front End Mode.
LED/Sounder Visual/Audible Condition
Slow blink
Rapid blink
Yellow LED
Steady
Very rapid blink
Steady red
Bi-color LED Steady green
Quick double red/green flash
Rapid red, yellow, green
All LED's
sequencing
Sounder Very quick beep (10 ms) with
(system) yellow LED blink every second
Sounder (after
Single long beep
PIN)
Sounder (after
1 short beep
card)
3.3.18

Wiegand Front End Mode Default Settings

Option
Master Code
Visual Keypress Feedback Enabled
Wiegand RED LED
Wiegand Green LED
Pulse Width
Page 68 of 86
Table 9: prox.pad LED Indicators/Sounder – Wiegand Mode
Default Setting
1234
Enabled
Enabled
8 = 160μS
Description
Unit is in Program mode
Verify mode is active (checking that the last two values in
sequence match)
Program error; entry error lockout (no keypress feedback)
Memory (eeprom) erase is in progress (command 46)
Lock is locked
Lock is energized (timed or latched)
Prox card read correctly
Power on/reset
EEPROM read error during get system parameters; can
be turned off by running self-test
Value entered too big, cannot be represented in 16 bits
(Wiegand mode)
Valid card access
Option
Audio Keypress Feedback Enabled
Auto-Entry
Red LED Active State
Green LED Active State
Inter-pulse Spacing
Default Setting
Disabled
Low
High
32 = 640μS
Document # 6055676, Rev 2.2, D4b