Operation Error - MUTOH ValueCut VC2-1800 Maintenance Manual

Operation Error

This section describes the contents of errors with messages as well as the check items and recovery
actions. These messages are displayed when an abnormal condition occurs during operation.
Error
VC2E-MM-00
Abnormal condition in CR motor
(Y-axis)
Error on UP/DOWN pen operation
AAS detection failed
Event/Symptom
Media detection failed
Receive undefined command
Connection error on RS-232C port
Data on the out of print range
AAS data exceeds 4MB
61
MAINTENANCE MANUAL
Remove the obstacle that prevents the Y-axis
operation.
Check "Y Encoder" and "Carriage Movement"
in self-diagnosis.
<Parts may be broken>

Y-motor

Main board Assy
Adjust length of the cutter blade.
Remove the obstacle
UP/DOWN operation
Check if a media is jammed on the machine.
"Holder
Check Encoder"
Movement" in self-diagnosis.
<Parts may be broken>

AASII carriage board Assy

Watch dog-Interface converter board Assy

Main board Assy

Flat cable Assy
Check print quality for "Reg mark"
Adjust the scale properly.
<Parts may be broken>
Carriage Assy
Troubleshooting
Switch the Pinch Roller enabled.
Check the data send from computer.
Set the communication condition.
Send the data within print range.
Edit AAS data to be less than 4MB.
that prevents the
"Holder
and