Replacing Tool Carriage - MUTOH ValueCut VC2-1800 Maintenance Manual

MAINTENANCE MANUAL

Replacing Tool Carriage

Please follow the steps below to replace the tool carriage.
Retaining Screws
Adjustment Screws
1. Loosen the 2 retaining screws (No need to remove them), and then turn
the 2 adjustment screws anti-clockwise to loosen the carriage belt.
3. Pull out the cable lock, and remove
2. Pop up the plastic locking pins using a
the belt.
flathead screwdriver.
Nut A
Bolt B
5. Loosen the Bolt B.
4. Remove the Nut A.
VC2E-MM-00
28