Replacing X-Motor
Please follow the steps below to replace the X-motor.
1.
Loosen the 4 retaining screws securing
the bracket. (No need to remove them)
3. Disconnect the 2 cables connected to the
motor.
5. Remove the X-motor.
VC2E-MM-00
2. Loosen the tension adjustment screw.
(No need to remove them)
4. Remove the 4 screws securing the X-motor.
1:
Install the X-motor in the reverse order of removal.
2:
Belt tension adjustment is required after the
replacement.
For details, refer to "Belt Tension Adjustment".
3:
Please connect the cables to the X-motor after the
belt tension adjustment is completed.
31
MAINTENANCE MANUAL