Using Routed Pppoa - Alcatel AST570 User Manual

11.2 Using Routed PPPoA

Access methods for PPP
PPPoA configuration
3EC 17766 AAAA TCZZA Ed. 04
Three methods exist to open a Routed PPPoA session:
Dial in
"
The session is opened manually
Always on
"
After the AST570 is powered and finished its POST
successfully, the AST570 automatically tries to open the
session
Dial on demand
"
The session is opened automatically, triggered by the arrival
of packets at a/the AST570 Ethernet port, destined for a
Routed PPPoA connection.
Per default, following Routed PPPoA connections are
preconfigured:
DIALUP_PPP1: dial in connection
"
DIALUP_PPP2: always on connection
"
DHCP_SPOOF: spoofing connection.
"
In case these entries do not meet your requirements, you can
configure a new one as follows:
1. If needed, add an PPPoA phonebook entry with the correct
VPI/VCI on the 'Phonebook' page.
2. On the 'PPP' page, select this phonebook entry from the
'Destination' pop down list.
3. For this entry, select PPPoA in the 'Protocol' field.
4. Select the correct encapsulation method from the
Encapulation' pop down list.
5. Optionally, enter user name and password.
6. Click .
7. Optionally, perform detailed configurations.
See section 9.3 for more information.
11 Configuration and Use - Routed PPPoA
111 / 300