Alcatel AST570 User Manual page 75

The 'MER Settings'
table
'MER Settings' table
components
3EC 17766 AAAA TCZZA Ed. 04
The following figure shows the 'MER Settings' table:
Field Description
Intf Indicates the interface name for the Routed Ethernet entry.
Interface Note: In most cases, the interface name will be the same as
the phonebook entry name.
Address Indicates the phonebook entry used by the Routed Ethernet
entry.
Indicates the state of the Routed Ethernet interface.
State
Note: Unless the interface is created via the CLI, Routed
Ethernet entries are always in state connected.
Encap Indicates the applied encapsulation method for Ethernet
Encapsulation frames(*) on the VC.
The AST570 supports both the LLC/SNAP method (default)
and the VC MUX method.
FCS Indicates whether the last four bytes of the Ethernet frames
are preserved or not. By default the FCS is set to NO.
Note: You can set the FCS to YES via the CLI.
IP Address Indicates the negotiated IP address and netmask used by the
Routed Ethernet entry.
IP Netmask
In case DHCP is checked (n) this IP address is dynamically
assigned by the remote DHCP server. If DHCP is unchecked,
you must enter a static IP address for the local side of the
Routed Ethernet connection.
7 Configuration and Use - Routed Ethernet
75 / 300