Alcatel AST570 User Manual page 145

Adding CIP members
Result
3EC 17766 AAAA TCZZA Ed. 04
Proceed as follows:
1. Browse to the 'CIP' page.
Addition of a CIP member is performed in the 'CIP Interfaces'
table.
2. If needed, click
3. Enter in the following CIP member parameters:
Local IP address
D
The IP address of the CIP member at your local side of
the LIS.
Mask
D
The associated classful or classless netmask/subnetmask
for this local IP address.
4. Click
A CIP member of the LIS is created at your AST570' CIP interface
side of the LIS. The local IP address is added to the 'IP Address'
table.
Two default routes are added to the 'IP Route' table, both pointing
to the AST570 as gateway, but the first with the CIP member itself
as destination, the second with the LIS subnetwork IP address pool
as destination.
12 Configuration and Use - CIP & IP Routing
in the 'CIP Interfaces' table.
and to finish the procedure.
145 / 300