Static Ip Address Configuration - Alcatel AST570 User Manual

14.3.2

Static IP Address Configuration

Default AST570 IP
address
In this subsection
Setting an IP address
via the 'Initial Setup'
page
3EC 17766 AAAA TCZZA Ed. 04
In case you add the AST570 to an existing (W)LAN, it could be
that you must configure a User Defined" IP address other than
the default Net 10" address, appropriate for the (W)LAN's IP
settings.
Setting an IP Address via the 'Initial Setup' Page
"
Setting an IP Address via the 'Routing' Page.
"
Proceed as follows:
1. Click
up the 'Initial Setup' page (See section 21.2 for more
information). On this page the following table is shown:
2. Enter an IP address in the 'IP Address' field.
3. You must configure a netmask for applying subnetting in your
network in the 'Subnetmask' field.
4. Click . As a result the new IP settings are applied:
5. To verify connectivity, point your Web browser to the new IP
address. Make sure though that your PC shares the same
subnet.
6. Click
storage.
in the left pane of the AST570 pages to pop
to store the applied IP settings to permanent
14 Networking Services - IP
175 / 300