Pppoa To Pptp Relaying Packet Service Configuration - Alcatel SPEED TOUCH HOME User Manual

2.3.5

PPPoA to PPTP Relaying Packet Service Configuration

PPPoA to PPTP
Relaying configuration
Creating a PPTP
connection icon
3EC 17058 AAAA TCZZA Ed. 04
All manuals and user guides at all-guides.com
Per default, following PPTP phonebook entries are available for
PPPoA/PPTP connections:
RELAY_PPP1 (PPTP on 8.48)
"
RELAY_PPP2 (PPTP on 8.49)
"
RELAY_PPP3 (PPTP on 8.50)
"
RELAY_PPP4 (PPTP on 8.51)
"
In case these PPTP phonebook entries do not meet your
requirements, you can configure a new one as follows:
1. If needed, add a PPTP phonebook entry with the correct
VPI/VCI on the 'Phonebook' page.
2. On the 'PPTP' page, select this phonebook entry from the
'Name' pop down list.
3. For this entry, select the correct encapsulation method.
4. Optionally, select the type of HDLC Framing.
Note: Only in very exceptional cases the default HDLC framing (Never)
must be altered.
5. Click and
Most PPTP Tunneling applications provide a Graphical User
Interface (GUI) guided procedure for the initial creation of a PPTP
session icon.
The result of such creation is in most cases an icon or entry in a
folder or a table called 'RAS', 'Dial Up Networking', 'PPTP', 'Call
sessions', 'Remote Access', etc.
2 Speed Touch Configuration Guide
to finish the procedure.
31 / 104