First Time Wireless Client Connectivity - Alcatel AST570 User Manual

4 WLAN Guide - Wireless LAN
4.1.2

First Time Wireless Client Connectivity

Initial AST570
configuration
Preconditions
42 / 300
When the AST570 leaves the factory and after every
Ping to Defaults or Push to Defaults, the AST570 Wireless
configuration returns to its initial default settings.
These settings are as follows:
Service Set ID (SSID)
"
The default SSID is printed on the marking label which can be
found on the bottom of your AST570. This unique SSID exists
of the word Alcatel" followed by (directly concatenated) the 6
last characters of the AST570 WLAN access point MAC
address.
Direct Sequence Spread Spectrum (DSSS) channel
"
number
The channel number possible values are dependent of the
regulatory domain where you purchased the AST570 (FCC 1
to 11 and ETSI 1 to 13). By default the AST570 DSSS channel
number is 11.
Wired Equivalent Privacy (WEP) Algorithm
"
WEP encryption is by default turned OFF.
WLAN Client Access Control
"
Access Control is by default turned ON.
Therefore, the WLAN client must be appropriately configured and
authenticated for initial Wireless connectivity to the AST570 WLAN
environment.
Make sure that:
Your AST570 is powered on and finished its POST
"
The WLAN adapter is readily installed on your PC
"
The PC's WLAN adapter is configured as DHCP client or has
"
a fixed Net 10" IP address
The WLAN adapter is correctly configured for the default
"
AST570 SSID.
3EC 17766 AAAA TCZZA Ed. 04