Trim & Barrier Screen - Valor L2 1700KN Installation Manual

Installation
Install trim plinth support
Install the trim plinth support hooking it vertically on
the stiff ener bracket, as shown. The stiff ener bracket is
located just behind the front panel below the window.
Plinth
support
Stiff ener
bracket
Install Trim and Barrier Screen
Install the trim chosen by the customer for their
fi replace. Install as well the barrier screen which is
provided with the trim.
Show the customer how to remove the barrier screen
to access the controls.
Follow the instructions provided with the trim and
leave those instructions behind for the customer's
further reference.
Trim & Barrier Screen
1730CIK—Clean Installation Kit
WARNING
HeatShift System MUST be installed on
this appliance when using 1730CIK—Clean
Installation Kit.
If you are installing the 1730CIK Clean Installation Kit,
you need to do it BEFORE the cement board.
1. Break off tabs from each corner of the fi replace's
front opening (8 tabs, 2 at each corner). Bend tabs
back and forth to break them, or cut them with tin
snips as indicated in the kit's installation instruc-
tions.
2. Remove the internal convection baffl e inside the
appliance case, above the fi rebox. See "Appendix
D—HeatShift™System" on page 74
59