Table of Contents
Advertisement
Installation
Install HeatShift Take-Off Collars to Appliance
1. Remove the four cover plates on top of the appli-
ance case (6 screws each).
2. Install the take-off collars on the holes on top of the
appliance's case (6 screws each).
WARNING
A l l F O U R ( 4 ) t a k e o f f s M U S T B E
C O N N E C T E D T O P L E N U M ( S ) .
HeatShift™ System—if used
Remove Convection Baffl e
To be eff ective, the HeatShift system requires that an
internal convection baffl e located above the fi rebox
inside the appliance case be removed to allow the hot
air fl ow to convect upwards into ducts installed on the
fi replace.
Remove the convection baffl e from the appliance. It is
held in place by 3 screws located right behind the upper
edge of the fi replace opening. Recycle this panel as it is
no longer needed.
Appliance front panel—shown transparent for clarity
C o
n v e
c t i o
n b
a ffl
Remove convection baffl e
See "Appendix D—HeatShift™System" on page 74 for
more details regarding the installation.
WARNING
The Linear fireplaces requires the
removal of the internal convection baffle
for the HeatShift system to function
properly—read instructions carefully!
e
33
Advertisement
Table of Contents
