Table of Contents
Advertisement
Installation
Accessories
Side Shrouds
The side shrouds are required to install the front on
the appliance. They are supplied with the engine.
Fit them to the appliance outer case as indicated
(2 screws/side).
Note that some backing plate may need to be installed
before the shroud. See instructions supplied with the
front, trim, backing plate for installation specifi cs.
Front, Trim and Barrier Screen
Install the front, trim or backing plate chosen by the
customer for their fi replace. Install as well the barrier
screen which is provided with the front or trim.
Show the customer how to access the controls when
the front or trim are installed and how to remove them.
Follow the instructions provided with the front, trim
and backing plate and leave those instructions behind
for the customer's further reference.
Handset Wall Holder
The remote control kit for this fi replace comes complete
with a wall-mounted holder. This holder is not required
in all installations but is provided as an optional feature
for those customers who wish to mount the remote
handset to the wall.
To install the holder to the wall, fi nd a convenient
location and use the hardware provided with the kit.
See the diagram below for required
hardware and confi gurations. Note
Alternative 2
Contents
Alternative 3
that the holder can be installed at
1 Wall Bracket A
Switch Plate
the base of a light switch plate.
2 Screws B
IMPORTANT. The location of the
1 Screw C
remote control handset is important
2 Wall Anchor D
1 Spacer E
to assure proper temperature
(detach before
regulation. To obtain a constant
assembly)
temperature, we recommend that
the handset should be between 3
1 Wall Bracket F
and 15 feet away from the appliance
Alternative 1
but not directly above it. We also
advise that the handset should be
located away from any other heat
source and not in direct sunlight
as this may aff ect the temperature
sensor located in the remote
handset.
32
Advertisement
Table of Contents
