Hanyoung TH500 Manual page 89

7.5.3 Operate and stop of program control
Set the connection pattern as 1 (own number) within the pattern repetition/connection setting [FIG 140] screen.
Input the each of pattern number and segment number in the program start pattern and start segment setting
unit within pattern of program control operation stop [FIG 141] screen and press the button then program
control operation will be started. In order to stop the program control operation, press the button on the
right-bottom of the program control operation [FIG 142] screen then program control operation will be stopped.
When operating the program control, the displaying screen will be same as the program control operation
[FIG 142], program control status indicating screen [FIG 143] and graph displaying [FIG 144] screen.
[FIG.140] Pattern repeat / Connection setting screen
[FIG.141] Program control 1st operation stop screen
[FIG.142] Program control 1st operation screen [FIG.143] Program control 2nd operation screen
[FIG.144] Graph display screen
90